Debug UART FYI - FriendlyELEC-Forum

Power & Source of Big Ideas

Skip to content

Debug UART FYI

Moderators: chensy, FATechsupport

3 posts Page 1 of 1

Post a reply

Debug UART FYI

: chaton78

: Posts: 1; Joined: Sat Apr 18, 2020 3:44 pm

Sat Apr 18, 2020 3:48 pm

by chaton78 » Sat Apr 18, 2020 3:48 pm

The debug UART is set at 1500000 (not a typo)
HW and SW flow controls off

Re: Debug UART FYI

: db215

: Posts: 2; Joined: Fri Apr 17, 2020 7:19 pm

Fri Apr 24, 2020 2:37 pm

by db215 » Fri Apr 24, 2020 2:37 pm

chaton78 wrote:
The debug UART is set at 1500000 (not a typo)
HW and SW flow controls off

Is there any way to change this, either through re-compile or run-time?

Re: Debug UART FYI

: jayanta525

: Posts: 6; Joined: Mon May 25, 2020 10:07 am

Mon May 25, 2020 10:28 am

by jayanta525 » Mon May 25, 2020 10:28 am

You can change it by modifying the DTS file. and recompile the OS again.

Post a reply

3 posts Page 1 of 1

Return to “R2S/R2C/NEO3 Hardware”

Who is online

In total there are 12 users online :: 0 registered, 0 hidden and 12 guests (based on users active over the past 5 minutes)
Most users ever online was 13606 on Thu Mar 26, 2026 3:27 pm

Users browsing this forum: No registered users and 12 guests

Powered by phpBB® Forum Software © phpBB Limited