How to check if my Neo is V.1 or V1.1 ?

: Waz

: Posts: 11; Joined: Sun Jun 26, 2016 6:41 am

Mon Oct 17, 2016 6:42 am

by Waz » Mon Oct 17, 2016 6:42 am

Hi,

I have a bunch of V1 NEO on my desk and recently ordered a new batch I presume is V1.1.
How can I visually identify the different versions ?

Cheers,

Re: How to check if my Neo is V.1 or V1.1 ?

: HermannSW

: Posts: 81; Joined: Tue Aug 09, 2016 9:06 pm

Mon Oct 24, 2016 9:23 pm

by HermannSW » Mon Oct 24, 2016 9:23 pm

This is v1.1, with the new 5 Audio pins on left bottom corner:

v1.0 does not have the 5 Audio pins.

Hermann.

Re: How to check if my Neo is V.1 or V1.1 ?

: boxxofrobots

: Posts: 1; Joined: Mon Apr 10, 2017 9:29 pm

Mon Apr 10, 2017 9:36 pm

by boxxofrobots » Mon Apr 10, 2017 9:36 pm

According to the schematic, con2 (1x12) bonds out USB and audio. According to the site, con2 bonds out usb and i2c. Which is correct? Is audio available without using the 2mm 5 pin connector?

Re: How to check if my Neo is V.1 or V1.1 ?

: jjm

: Posts: 156; Joined: Tue Dec 15, 2015 8:05 am

Tue Apr 11, 2017 7:57 am

by jjm » Tue Apr 11, 2017 7:57 am

Hi All,

About the Hardware_Differences_Among_Different_Versions of the NanoPi NEO , you can see this link which has detailed introduction : http://wiki.friendlyarm.com/wiki/index. ... t_Versions

thank you!

Who is online

In total there are 18 users online :: 0 registered, 0 hidden and 18 guests (based on users active over the past 5 minutes)
Most users ever online was 27070 on Thu Jul 09, 2026 6:53 am

Users browsing this forum: No registered users and 18 guests