FriendlyELEC-Forum

FriendlyARM released a GPS module for the NanoPi2.

Please refer to the following link for more details:
http://www.friendlyarm.com/index.php?ro ... duct_id=93

Hi ,

I am using NANO PI R1.
https://www.friendlyarm.com/index.php?r ... uct_id=248

I need to setup matrix GPS-01 with nano pi R1,

Please guide on installation on 4.19.38-sunxi.

Thanks you
Bharat

friendluff wrote:

bharatdhuri wrote:
Hi ,

I am using NANO PI R1.

I need to setup matrix GPS-01 with nano pi R1,
https://www.friendlyarm.com/index.php?r ... uct_id=248 basketball legends

Please guide on installation on 4.19.38-sunxi.

Thanks you
Bharat

I also hope someone can give me detailed instructions on how to install on 4.19.38-sunxi.

I am also learning about how to install this app. Hope someone knowledgeable will help

bharatdhuri wrote:
Hi ,

I am using NANO PI R1.
https://www.friendlyarm.com/index.php?r ... ct_id=248_cookie clicker

I need to setup matrix GPS-01 with nano pi R1,

Please guide on installation on 4.19.38-sunxi.

Thanks you
Bharat

This is likely a standard GPS module that communicates via UART (serial) and outputs NMEA 0183 sentences. It typically has VCC (power), GND (ground), TX (transmit), and RX (receive) pins.

oliviawilde168 wrote:

bharatdhuri wrote:
Hi ,

I am using NANO PI R1.
https://www.friendlyarm.com/index.php?r ... ct_id=248_Curve Rush

I need to setup matrix GPS-01 with nano pi R1,

Please guide on installation on 4.19.38-sunxi.

Thanks you
Bharat

This is likely a standard GPS module that communicates via UART (serial) and outputs NMEA 0183 sentences. It typically has VCC (power), GND (ground), TX (transmit), and RX (receive) pins.

yes, the wire is the GPS module that allows to locate and determine the position of each transmission line and it usually has VCC, GND, TX and RX pins